All commercially available, bulletproof rear sights can be mounted on the Sport extra rear sight carrier.
The multi-adjustable diopters Flex are available in different colors.
Adjust the height of the line of sight
Loosen both side M6 screws with a SW 3 key.
Infinitely variable adjustment of the upper part of the rail as required using the rimmed nut (scale with 1mm intervals on the bolt)
Tighten the screws fully again. (check for tight fit after a few shots)
Stepless adjustment of the sight line height up to 8mm below the standard dimension. The grain carrier must be adjusted by the same amount in each case.
Assembly instructions for the rear sight carrier
Remove the locking ring and the visor pusher with the spring from the perforated visor.
Knock out the 4mm roll pin and remove the hole sight with the small parts.Put the rear sight carrier W 57 Sport over the now protruding rear sight base.
Push the supplied 4mm pin through the cross hole of the rear sight carrier and the mount on the lock housing.
If your gun does not have a prepared scope mount (Figure 1), fully tighten the screw, which is mounted at a 45 degree angle.
has a prepared scope mount (Figure 2), remove the screw at a 45 degree angle. Take the supplied 10mm long screw and tighten it fully in the vertical threaded hole.